Getting Started; Charging The Battery Pack; Insert An Sd Card - JVC GZ-MS90AS Manuel D'instructions

Getting Started

Charging the Battery Pack

1
Close the LCD monitor to turn off the
camcorder.
2
Attach the battery pack.
Slide the battery pack until it locks in
place.
3
Connect the AC adapter.
DC Jack
AC Adapter
•
The charge lamp blinks to indicate charging
has started.
•
When the lamp goes out, charging is
finished.
Required charging/recording time
(approx.)
* When the monitor backlight is set to
[BRIGHTER] mode.
Battery pack
BN-VF808U
(Provided)
BN-VF815U
BN-VF823U
L
To detach the battery pack
Slide and hold BATT., then remove the
battery pack.
L
To check the remaining battery power
See page 9.

battery pack.
To AC Outlet
(110V to 240V)
Charging time Recording time
1 hr. 30 min. 1 hr. 55 min.*
2 hr. 40 min. 3 hr. 55 min.*
3 hr. 50 min. 5 hr. 55 min.*
NOTES
•
You can also use the camcorder with just
the AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
High
Displays the remaining battery power.
As the battery power comes close to nil,
the battery indicators blink. When the
battery power is exhausted, power turns
off automatically.
Charge
lamp

Insert an SD Card

•
Operations are confirmed on the following
SD cards.
Class 4 or higher compatible SD or SDHC
BATT.
card
Panasonic, TOSHIBA, SanDisk, ATP SD
card (256 MB to 2 GB) or SDHC card (4 GB
to 16 GB)
•
If other media are used, they may fail to
record data correctly, or they may lose data
that had already been recorded.
•
MultiMediaCards are not supported.
•
Cards used to record video on this
camcorder cannot be played back on other
devices.
•
Some card readers (including internal card
readers in PCs) may not be able to support
SDHC format. Please use the camcorder or
other SDHC compatible devices to access
the card.
1
Close the LCD monitor to turn off the
camcorder.
2
Open the SD card cover.
Exhausted