Cleaning; Maintenance And Repair; Warranty - Welch Allyn LS200 Manuel De L'utilisateur

(a) FUSE DRAWER
(b)
SNAP
CONNECTION
FUSES

CLEANING

Turn power switch to the OFF position and unplug the power cord from
the electrical outlet prior to cleaning.
The entire unit can be wiped down using a cloth dampened slightly with
a mild solution of detergent and water or glass cleaner. Be careful not to
allow the plug prongs to get wet. Wipe the unit dry with a clean, dry cloth.
DO NOT plug the LS200 Procedure Light into the electrical outlet until the
unit is thoroughly dry.
IMPORTANT
Be careful not to allow solution to drip into luminaire.
DO NOT spray solution directly into joints.
DO NOT sterilize any part of the unit.
DO NOT immerse any part of the unit in cleaning solutions.

MAINTENANCE AND REPAIR

For minor trouble, refer to the "Troubleshooting Guide" on page 15-16
for possible causes and corrective action.
Only qualified personnel should make electrical inspections of the
LS200 Procedure Light.
Repair: To locate qualified service personnel, contact your local, authorized
Welch Allyn distributor, or contact Welch Allyn directly at 800-535-6663.0.

WARRANTY

The LS200 Procedure Light is guaranteed by Welch Allyn against all
manufacturing defects. Welch Allyn will repair or replace, free of charge,
any parts of its own manufacture that prove to be defective for reasons
other than misuse, neglect, damage in shipment, or normal wear. This
warranty is in effect for three years from original date of purchase.
12