Zeegma Zonder Robo Vision Manuel De L'utilisateur page 14

EN
2. Sign up/ log in (see fig. 17)
•
Enter the application, enter your phone number or e-mail address. Enter your password
to receive the verification code. Next read and accept the Privacy Policy.
•
Enter the verification code in the empty field. Go further.
•
Next log in the application by entering the correct phone number or e-mail address
and password.
3. Scan the vacuum cleaner with QR code (see fig. 18)
•
Log in the application, click „+", scan QR code on mobile device and click „enter manually".
4. Connect to Wi-Fi network (see fig. 19)
The product supports Wi-Fi 2.4 GHz only, it does not support Wi-Fi 5 GHz.
Before you configure Wi-Fi, set router parameters. Wi-Fi password must not include
special characters.
•
Make sure the router and vacuum cleaner are close to each other to allow fast
configuration of the device.
•
Select the device and enter correct password, next click „next". Wait for connection to
Wi-Fi network.
5. How to reset device (see fig. 20)
•
Press the main switch on the device to turn the cleaner off.
•
Restart the device, press start/pause key and hold for 3-5 seconds.
•
The device is properly resetted if you can hear a sound.
6. If connection to Wi-Fi network fails
•
Select „compliance mode" and enter phone Wi-Fi settings site, connect to hot spot
robot###, return to application and keep waiting for connection.
•
You can follow the instructions displayed to find the cause of lack of connection and try again.
9. How to prepare rooms for vacuuming
1.
Remove cables and other items which may get tangled in the vacuum cleaner from the
floor (fig. 22).
2.
The vacuum cleaner is intended to clean floors and thin short-hair carpets. Do not use
the cleaner on long-hair carpets (fig. 23).
3.
Position the furniture in a way that the vacuum cleaner cannot get stuck (fig. 24).
4.
Remove all obstacles from narrow areas (fig. 25).
The pictures are for reference only. The real design of the products may differ from the
pictures presented.