How To Use - Zeegma Zonder Robo Vision Manuel De L'utilisateur

EN
Dustbin (see fig. 4):
1.
HEPA filter
2.
Preliminary filter
3.
HEPA filter sensor
Docking station (see fig. 5):
7.
Power LED
8.
Power port
9.
Charging port
Remote control (see fig. 6):
10.
Return to docking station
11.
Forward key
12.
Start/pause key
13.
Turn right
14.
Turn left
3. How to assemble (see fig. 7):
•
Fix the side cover for dust bin emptying: Firmly press the side cover and adapt to two
fasteners.
•
Close the side cover for dust bin emptying.
•
Install the dustbin in the relevant place of the vacuum cleaner.
•
Before you use the product, remove the protective strip.

4. How to use:

How to place and charge:
•
Place the docking station by the wall, on a flat surface. Leave some free space around
the station, that is 0,5m to the left and right, and 1,5m before the station (see fig. 8).
•
Supply power to the docking station and plug in (see fig. 8).
•
Fix side brushes, left and right (L/R) (see fig. 9).
•
Activate the main switch of the product. „I" stands for ON, and „O" means OFF (see fig. 9).
Two ways of charging (see fig. 9):
1.
Place the product on the docking station.
2.
For charging, use the power supply (when charging, the signaling light flashes, when
charging is over, it turns green).
4.
HEPA filter cover
5.
Correct tank assembly sensor
6.
Side cover for tank emptying
15.
Reverse key
16.
Edge cleaning
17.
Spot cleaning
18.
Suction power adjustment