About This Guide; System Requirements; Unpacking The Product; Optional Accessories - D-Link DWL-6620APS Guide D'installation Rapide

About This Guide

This installation guide provides basic
instructions for installing the DWL-6620APS
Unified AC Concurrent Dual-Band PoE
Access Point on your network. For additional
information about how to use the access
point, please see the User Manual,
which is available on the CD included in
this package or from the D-Link support
website.

System Requirements

- CD-ROM drive
- Windows , Macintosh
®
operating system
- An available Ethernet port
- Internet Explorer 11, Safari 7, Firefox 28,
Google Chrome 33 or higher

Unpacking the Product

Open the shipping carton and carefully
unpack its contents. Please consult the
packing list below to make sure all items
are present and undamaged. If any item is
missing or damaged, please contact your
local D-Link reseller for replacement.
- DWL-6620APS
- Power adapter*
- Mounting ring
- Console cable*
- CD-ROM
- Ceiling bracket (3 sets, sizes are 9/16",
14/16", and 1 1/2")
*The power adapter is an optional
accessory and not included in the
package in some regions. To power the
units, use a D-Link PoE switch or the
D-Link DPE-301GI PoE injector.
*The console cable is an optional
accessory and not included in the
package in Armenia, Azerbaijan, Belarus,
Georgia, Israel, Kaliningrad, Kazakhstan,
2  D-Link DWL-6620APS Quick Install Guide
, or Linux-based
®
Kyrgyzstan, Latvia, Lithuania, Moldova,
Mongolia, Russia, Turkey, Turkmenistan,
Ukraine, and Uzbekistan. If a cable is
required, please contact your reseller to
order it (Model: ACS-AP-CONSOLE).

Optional Accessories

- PoE Injector (Model: DPE-301GI)
Note: These accessories are not included
in the package. If any of these items are
required, please contact your reseller to
order it.

Hardware Overview

LEDs
Figure 1. DWL-6620APS LEDs
POWER When this LED is red,
the access point is
booting up. When it is
green, it is ready for
use.
LAN1/LAN2 When this LED is lit, the
device's Ethernet port is
connected to an active
router or switch. The
light will flash when data
is being transmitted
through the port.
2.4GHz/5GHz When the LED is lit, the
access point's wireless
radio is enabled. It will
flash when data is being
transmitted via wireless.