Table des Matières
Publicité
•
Manage the access point from the
computer via the Unified Wireless
Switch or Wireless Controller: Connect
the access point to a Unified Wireless
Switch or Wireless Controller. Connect
your computer to the same network as
that of the Unified Wireless Switch or
Wireless Controller. Log in to the Unified
Wireless Switch web administration page
or Wireless Controller web administration
page. For the default login information
please see Unified Wireless Switch
user manual or Wireless Controller user
manual.
Unified Wireless
DWL-6620APS
Wireless Controller
Mounting Options
You can mount the DWL-6620APS access
point on any of the following types of surfaces:
• Solid surface wall or ceiling
• Tabletop
Cable Requirement
Use a CAT 5 cable with an even sheath.
The Ethernet ports on the DWL-6620APS
access point cannot accept a CAT 5 cable that
has an uneven sheath; the RJ-45 connector
on the cable will not fit properly into the
receptacle on the access point.
Wall Installation Recommendations
If you plan to install the DWL-6620APS on a
wall or other vertical surfaces, orient the top
of the access point (the side with the LEDs)
toward the intended coverage area. The
radio antennas transmit through the top of
the access point but not through the bottom
(where the bracket is).
Warning: The DWL-6620APS is designed
to receive PoE power only from an 802.3at-
compliant source, or from a D-Link-approved
power adapter. Connecting an access point
to a Power over Ethernet (PoE) device that
is not approved by D-Link can damage the
equipment.
4 D-Link DWL-6620APS Quick Install Guide
Computer
Switch
or
Warning: This product is to be connected
only to PoE networks without routing to the
outside plant. The equipment power cord
must be connected to a socket-outlet earthling
connection.
Avertissement: Le DWL-6620APS est
concu pour recevoir de l'alimentation PoE
uniquement a partir d'une source compatible
802.3at ou d'un adaptateur secteur approuve
par D-Link. La connexion d'un point d'acces
a un peripherique Power over Ethernet(PoE)
non approuve par D-Link peut endommager
l'equipement.
Avertissement: Ce produit doit etre connecte
uniquement aux reseaux PoE sans
acheminement vers l'installation externe. Le
cordon d'alimentation de l'equipement doit
etre branche sur une prise de terre avec prise
de courant.
Mounting Using Anchor Screws
Installation
1. Place the plastic wall mounting ring on a
wall or ceiling. Mark the points where you
will insert the screws, then remove the
mounting ring.
2. Drill holes in the marked points and
insert the plastic wall anchors.
3. Use the supplied screws to attach the
mounting ring to the wall.
4. Plug the CAT 5 cable into the LAN port on
the access point.
Publicité
Table des Matières
