Before First Use; Operation; Cleaning & Maintenance - Inventum KP521 Mode D'emploi

3
before the first use
Before you use the appliance for the first time, please do
as follows: Carefully unpack the appliance and remove all
the packaging material. Keep the material (plastic bags and
cardboard) out of reach of children. Check the appliance after
unpacking for any damage, possible from transportation.
Place the appliance on a stable and heat resistant surface.
Clean the appliance with a damp cloth. The hotplate(s) has
(have) a protective layer which should be removed before the
first use. Switch the hot plate on for about 5 to 6 minutes on the
maximum position. There can be a slight development of smoke
from the protective layer which is now burning of. After removing
the protective layer you can now switch the hot plate of or begin
using it.
4

operation

The thermostat button is adjustable:
OFF = off
MIN = low
MAX = high
Make sure the thermostat button is set to position «OFF» before
you switch on the appliance. Plug the appliance into a socket.
For heating the hot plate(s) turn the knob clockwise. The red
control light will burn. Position «MIN» is the lowest position and
position «MAX» is the highest position. It takes about 10 minutes
before the hot plate has reached the maximum temperature
(on the maximum position of the thermostat knob). If the
temperature is reached which conforms to the set position, the
control light will go out. After a temperature drop, giving of heat
to the pan, the thermostat and the control light will switch on.
ATTENTION: THE APPLIANCE CAN GET HOT DURING USE.
THEREFORE ALWAYS PLACE THE APPLIANCE ON A HEAT
RESISTANT SURFACE AND NEVER ON A PLASTIC TABLE OR
PLASTIC TABLE CLOTH.
Use only pots with a bottom which has the same cross­cut as
the hot plate. A smaller cross­cut will lead to energy loss. Model
KP521 has a cast iron plate with a cross­cut of 185 mm and a cast
iron plate with a cross­cut of 155 mm.
Do not touch the hot plate when in use. Be careful: the hot
plates need time to cool down after switching the appliance of.
Always unplug the hot plate after every use.
5
cleaning & maintenance
Let the appliance cool off and always unplug the appliance
before cleaning. Wipe the outside of the appliance with a damp
cloth and dry the kettle afterwards. Never use any abrasives! Be
aware of the fact that the appliance needs time to cool down
after switching of.
Never immerse the appliance in water or others liquids.
11
English •