Bebeconfort MiloFix Mode D'emploi page 39

A - Cover
B - Head support
C - 5 point Harness
D - Recline handle
E - Rear-facing/forward facing switching handles
F - ISOFIX connectors
G - Base
H - ISOFIX clips activation handle
I - TOP-TETHER rear-facing belt passage
J - Headrest adjustment
K - TOP-TETHER belt
L - Instruction leaflet compartment
M - Support pillow for new born child
N - Carrying
O - Shoulder pads
P - Belts hooks
Q - Harness adjuster
R - Top tether storage pocket
SAFETY
• All Bébé Confort products have been carefully
designed and tested for your baby's safety and
comfort. Use only accessories sold or approved by
Bébé Confort. Using other accessories may prove
to be dangerous.
• Please read these instructions carefully and make
yourself familiar with the product before using it.
• Always keep the instructions for future reference;
there is a storage compartment specifically
provided on the child seat.
• During installation of MiloFix on your seat, use
the bar in the front of MiloFix in order to insert
your MiloFix at the maximum. Make an alternative
movement on the left and on the right.
The Bébé Confort MiloFix car seat in the car:
• SEMI-UNIVERSAL ISOFIX SYSTEM in rearward
facing position (Gr0+ / 0 - 13 kg), class size C,D,E.
• Before using the ISOFIX anchorage system, you
must IMPERATIVELY read the instruction manual
of the vehicle, before installing your child car seat.
This manual will indicate the places compatible
with the class size of the car seat, SEMI-UNIVERSAL,
UNIVERSAL ISOFIX approved.
• UNIVERSAL ISOFIX SYSTEM in forward facing
position (Gr1 / 9 - 18 kg), class size B1.
Baby in the Bébé Confort MiloFix car seat:
• In the rear-facing position, the MiloFix car seat is
automatically placed in the maximum reclining
position, therefore, the angle of recline handle
cannot be used for safety reason.
• Never leave a child unsupervised.
• Never leave the child alone in the car.
• Even a gentle impact on a vehicle can turn a child
into a projectile.
• For your own safety and that of your child, always
put the child in the child car seat, however short
your journey may be.
• Ensure that the straps under the stomach lie as low
as possible, to properly support the pelvis.
• The temperature inside a vehicle may become very
high, particularly after a long period of exposure
to the sun. It is strongly recommended, under such
conditions, to cover the seat of the car with a piece
of material or something equivalent to prevent the
harness fixings, and in particular the metal parts,
from becoming hot and burning the child.
• After putting your child in the seat, ensure that the
harness straps are properly tight. Also ensure that
the strap is not twisted.
• After putting the child in the car seat, ensure that
the harness is sufficiently taut by pulling the belt.
Ensure also that the belt does not become twisted.
WARNING:
Never combine two ISOFIX anchorage and car seat belt
systems to install your child car seat.
EN
41