fortress EVOLVER Instructions D'installation page 9

Fig. 1
SECTION
VIEW
Fig. 3
post mount. Make certain that your rail slots are facing in the
POST INSTALLATION: EMBEDDED (NO FOUNDATION)
boards.
Step 1: Mount Post Base (Embedded/No Foundation)
1. Create a perimeter for the fence using Ground Stakes &
Guide String. If layout has 90° corners, confirm that corners
form 90° angles. As shown on page 7, Fig. 1.
2. Position Post Bases in corners along string.
3. Determine spacing required between Corner & Line Post
Bases. Spacing between each Post Base CANNOT exceed
73"[1860mm ] (Fence Board width is 70-1/2"[1791mm]).
Layout post spacing so that minimal panel cuts are
required. As shown in Fig. 1.
4. Once spacing is confirmed, Use spray paint to mark
post hole locations.
5. Holes should be 10" [250mm] in diameter. Check local
building codes for post hole depth.
6. Place Embedded Post Base into holes along Guide Strings.
Posts should have at least 12" [300mm] exposed
When slotting the post over the post mount. Make certain that your rail slots are facing in the
correct direction for your fence boards.
Installation Guide - 2017
FENCING INSTALLATION: EVOLVER
Fig. 2
TOP VIEW
Opposite Fence
Board Slots
5
5
Opposite
Fence
Board Slots
9