jcm-tech MICRO-DCS Mode D'emploi page 20

the "key command", the command used for programming the receiver. For
example, if the key command is a double channel recorded with button 2,
the new transmitters recorded "via radio" must also be recorded with button
2. If they are to be recorded with another channel of the new command,
this must be done manually.
• If no new transmitter is recorded in the space of 10 seconds, the receiver
automatically concludes the code memorisation phase, indicating this by
means of two short acoustic signals.
Note: To avoid waiting the 10 seconds, the memorisation phase can be
terminated by pressing the button in the rear of the transmitter which started
the programming or of the last to be memorised. Termination will be
indicated by two short acoustic signals.
PROGRAMMING VÍA ADDITIONAL RADIO TRANSMITTERS WITHOUT
"MASTER TRANSMITTER" (PIN-MODE)
In order to operate in this mode, it is necessary to first insert
an installation "PIN".
STOP
This "PIN" is a four-digit number, which is inserted, by means
of a MANAGER or MINIMAN portable programmer, into the
first transmitter which is recorded in the receiver. As from now,
the receiver recognizes the corresponding transmitter and automatically
records it in its memory, indicating this action by means of a very long
acoustic signal.
If you are working in this function
mode it can be useful to place
readable the sticker "PIN-MODE"
in order to facilitate the
programming procedure by the
end user.
19