jcm-tech MICRO-DCS Mode D'emploi page 18

Disconnect the power before working on the receiver
installation.
STOP
CHASSIS ATTACHMENT:
The receiver comprises four different pieces: a rear cover, circuit, front
curved cover and adjustable antenna.
• Attach the rear of
the box to the wall
using the plugs and
screws supplied.
• Slide the front of
the microreceiver
over the track in the
rear cover.
24V
12V
• Adjust the antenna.
• Do not position the active antenna less than 5 metres away from another
receiver and/or active antenna.
CONNECTIONS:
• Connect the power cables to terminals 1 and 2 in the printed circuit
board, as indicated on the plate label.
INSTALLATION
17
• Attach the circuit
to the rear of the
box.
• Pass the cables
through the bottom
of the
24V
microreceiver.
12V
• Screw the
antenna to the top
of the chassis.