Wine Guardian WRAWGHFSI Guide D'installation Rapide page 7

Fig. A (TTW) Fig. B
Fig. C (TTW) Fig D (Ducted)
Fig. E (TTW) Fig. F (Ducted)
Fig. G (TTW) Fig. H (Ducted)
5. Installing Freestanding Humidifier—with
power cord and humidistat
A. Follow Step 3 (TTW or within racking) or
Step 4 (surface mount), A-H.
B. Plug power adapter into 120 volt/1
phase/60 hertz receptacle. (Fig. A)
C. Mount independent humidistat within
wine room mid-point on wall or racking in
an area that has sufficient access. (Fig. B)
D. Refer to Humidistat Operations Manual
for additional information
E. Installation is complete.
6. Controller set-up instructions
A Locate the Wine Guardian remote
interface controller within the wine
cellar or proceed to the Wine
Guardian Through-the-Wall (TTW)
main control panel. (Fig. A & Fig. B)
B Press the settings button and hold it
down for five (5) seconds. The
screen will advance to the set up
menu and "1 F" or "Setting # 1" will
appear on the screen. (Fig. C & Fig.
D)
C Continue to press the settings
button to advance to setup screen
"6 0" or "Setting # 6". (Fig. E & F)
D Press the up arrow to advance this
setting to either "1" for Integrated
Humidifier (mounted at Wine
Guardian or "2" for Freestanding
Humidifier Unit. (Fig. G & H)
E Controller setup is complete.
7