Wine Guardian WRAWGHFSI Guide D'installation Rapide page 3

1. Unpack the unit
A. Remove unit from box. Check for any signs of
2. Installing Integrated humidifier
A. Turn the Wine Guardian ON/OFF switch to
Fig. A
B. Remove side access cover at the evaporator
C. Remove the humidifier adapter plate from
Fig. B
D. Slide the humidifier onto the studs located
Fig. C
E. Attach 1/4" (0.6cm) water supply line at top
F. Attach 1/2" (1.3cm) drain line at bottom of
Fig. D
G. Plug in power/control wire to Wine Guardian
H. Proceed to Step 6 Controller Set up.
Fig. E
Fig. F
concealed damage. Be sure all optional brack-
ets have been included. Contact Wine Guardi-
an immediately if components are missing or
unit has been damaged in shipping.
the OFF position. (Fig. A)
section of unit (section with supply and re-
turn ductwork to wine room). (Fig. B)
the humidifier box and secure it to the side
access opening using the eight (8) machine
screws provided with the humidifier kit. (Fig,
D)
on the adapter plate and secure using the
eight (8) nuts provided with humidifier kit.
(Fig. D)
of humidifier. (Fig. E)
humidifier. (Fig. F)
unit as shown at main control panel. (Fig. G)
Fig. G.
3