Filling Clean Water Tank; Auto Mode - Tineco FLOOR ONE S5 STEAM Serie Mode D'emploi

Filling Clean Water Tank

Press the Clean Water Tank release button to
remove it from the appliance.
Place the tank back into the appliance. You
should hear a "Click" if done correctly.
Cleaning Mode Selection

Auto Mode

• In Auto mode, the iLoop™ sensor automatically detects how dirty the floor is and applies the
appropriate amount of detergent and suction power.
• A red dirt monitoring loop indicates more dirt is detected, and a blue loop indicates less dirt is
detected. This mode automatically provides the best cleaning solution.
②
①
Open the tank cap, and fill with tap water to the
Max line.
Note:
Only use water under 140°F/60°C.
DO NOT USE HOT WATER.
11
MAX
Clean: on Min
Power
Vary depending
on dirt amount
Heavy dirt: on
Max Power