Getting Started; Cancel The Demonstration; Set The Clock And Date; Set The Basic Settings - JVC KD-R890BT Manuel D'instructions

GETTING STARTED

1

Cancel the demonstration

When you turn on the power for the first time (or [FACTORY RESET] is set to
[YES]), the display shows: "CANCEL DEMO" "PRESS ENTER"
1
Press .
[YES] is selected for the initial setup.
2
Press again.
"DEMO OFF" appears.
2

Set the clock and date

1 Press and hold .
2 Press to select [CLOCK], then press
To adjust the clock
3
Press to select [CLOCK ADJUST], then press
4
Press to make the settings, then press
Hour Minute
5
Press to select [CLOCK FORMAT], then press
6
Press to select [12H] or [24H], then press
To set the date
7
Press to select [DATE SET], then press
8
Press to make the settings, then press
Day Month Year
9
Press to exit.
To return to the previous setting item, press
4
ENGLISH
3
1
Press and hold
2
Press
press
3
Repeat step
4
Press
To return to the previous setting item, press
SYSTEM
KEY BEEP
SOURCE SELECT
AM SRC *
PANDORA SRC * ON: Enables PANDORA in source selection. ; OFF: Disables. ( 9)
IHEART SRC *
.
SPOTIFY SRC *
BUILT-IN AUX *
.
F/W UPDATE
.
UPDATE SYSTEM
.
F/W UP xxxx
.
.
FACTORY RESET
.
* Not displayed when the corresponding source is selected.
.

Set the basic settings

.
to select an item (see the following table), then
.
2
until the desired item is selected or activated.
to exit.
(Not applicable when 3-way crossover is selected.)
ON: Activates the keypress tone. ; OFF: Deactivates.
ON: Enables AM in source selection. ; OFF: Disables. ( 5)
ON: Enables IHEARTRADIO in source selection. ; OFF: Disables. ( 10)
ON: Enables SPOTIFY in source selection. ; OFF: Disables. ( 11)
ON: Enables AUX in source selection. ; OFF: Disables. ( 19)
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
YES: Resets the settings to default (except the stored station). ;
NO: Cancels.
.
Default: XX