Attention; Cleaning And Disinfection; Maintenance - Gima SP-10 Manuel De L'utilisateur

27

6.2 Attention

 Please check the device before using, and confirm that it can work normally.
 Rechargeable lithium battery.
 It is recommended that the device should be measured in room.
 Excessive ambient light may affect measurement accuracy. It includes fluorescent lamp, dual ruby light, infra-
red heater, direct sunlight and etc.
 Intense activity of the subject or extreme electrosurgical interference may also affect the accuracy.
 Please clean and disinfect the device after using according to the User Manual (7.1).
Chapter 7
MAINTENANCE,TRANSPORTATION AND STORAGE

7.1 Cleaning and Disinfection

Using medical alcohol to wipe the device for disinfecting, nature dry or clean it with clean soft cloth. It's necessary
to clean the turbine periodically for accuracy, keep the diaphaneity of the lucency part, and keep it away sundries
(such as hair or lesser sediment). Immerse the turbine in disinfectant after use, clean it with clean water and dry
standing vertically after soaked a few minutes (but don't make the turbine rinsed with water directly), this type
doesn't bring pollution to environment. (Note: The disinfectant is 75% alcohol).

7.2 Maintenance

1) Please clean and disinfect the device before using according to the User Manual (7.1).
2) Please recharge the battery when the screen shows low-power (the battery power is
3) Recharge the battery soon after the over-discharge. The device should be recharged every six months when it
is not regular used. It can extend the battery life following this guidance. If the battery is broken, DO NOT try to
maintain it by yourself, please contact us or the local service center.
4) The device needs to be calibrated once a year (or according to the calibrating program of hospital). It also can
be performed at the state-appointed agent or just contact us for calibration.
).