Operation; Transport; Storage; Care And Service - Kärcher NT 55/2 Tact2 Me I Mode D'emploi

5. Seal the dust bag (special accessories) with the
closing strip.
6. Take out the dust bag (special accessories).
7. Dispose of the dust bag (special accessory) in ac-
cordance with statutory provisions.
8. Replace the container and lock with the set down
mechanism bracket.
General
WARNING
Improper disposal of waste water
Environmental pollution
Observe the local waste water treatment regulations.
 We recommend switching off the "Automatic filter
dedusting" function when vacuuming wet dirt with
the crevice nozzle or the upholstery nozzle (option-
al), or when sucking mainly water out of a container.
 The device switches off automatically when the
maximum fluid level is reached.
 When vacuuming non-conductive liquids (e.g. drill
emulsion, oils and grease) the device does not au-
tomatically switch off when the container is full. The
filling level must be continuously monitored and the
container emptied on a timely basis.
 On completion of wet vacuum cleaning: Clean the
flat fold filter using the dedusting function. Clean the
electrodes and electrode extensions with a brush.
Clean the container with a moist cloth and dry it off.
Clip connection
The suction hose is equipped with a clip system. All ac-
cessory parts with a nominal width of 40 mm can be
connected.
Illustration H

Operation

Turn switch
Device ON
Automatic filter dedusting: OFF
Device OFF
Device ON
Automatic filter dedusting: ON
Switching on the device
1. Connect the mains plug.
2. Switch on the device at the turn switch.
Automatic filter dedusting
The device is equipped with a special double filter de-
dusting function, which is particularly effective against
fine dust. The flat fold filter is automatically cleaned
every 7.5 seconds by a blast of air (pulsing noise).
Switching off the device
1. Switch off the device at the turn switch.
2. Pull out the mains plug.
12
Each time after use
Emptying the container
WARNING
Risk of injury from the lifting mechanism
Crushed hands.
Under no circumstances should you hold your hands
between the dirt receptacle and spacer or allow them to
come close to the lifting mechanism while locking it.
Lock the container with both hands by actuating the set
down mechanism bracket.
1. Lock the parking brakes.
2. Pull the set down mechanism bracket upwards. The
container is unlocked and lowered.
Illustration C
3. Pull out the container by the handle.
Illustration D
4. Empty the container.
5. Replace the container and lock with the set down
mechanism bracket.
1. Vacuum off the inside and outside of the device and
clean with a moist cloth.
Storing the device
1. Store the suction hose and mains cable as shown in
the illustration.
Illustration I
2. Store the device in a dry room and secure it against
unauthorised use.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
1. Remove the suction hose with floor nozzle from the
support. Carry the device by the carrying handle and
suction pipe.
2. Load the device by the chassis handle and push
handle.
3. Pull the device behind you via the push handle for
transporting over longer distances.
4. When transporting the device in vehicles, secure it
to prevent it from slipping or overturning in accord-
ance with the respective valid guidelines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
The device may only be operated indoors.

Care and service

DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
English
Cleaning the device

Transport

Storage