Removal Of The Ice Cream / Yoghurt Mass; Follow-Up Cooling Function - CASO DESIGN IceCreamer Mode D'emploi

16.3.2 Removal of the ice cream / yoghurt mass

► Depending on the type of preparation, it is possible that the stirring process stops before
the set preparation time is reached. This is to protect the motor. The ice cream can be
removed.
► Only use a plastic or wooden spoon to remove the ice cream / yoghurt, do not use a
metal spoon, otherwise the surface of the container may be damaged.
► You can eat the yoghurt directly after cooling it or add fruit, honey, etc. You can cool the
container in the fridge.
► Ambient temperatures and the prepared yoghurt base influence the production time. If
you use chilled milk with yoghurt bacteria as a base, adjust the time accordingly. If you
use pure yoghurt as a base, then the production time should not exceed 10 hours.
11. Before remove the ice cream / yogurt, switch the device to standby mode using the
POWER button and unplug the power cord from the wall outlet.
12. Open the lid to subsequently remove the container from the appliance.
13. Remove the mixer (if present) and refill the mixture into an appropriate container.
a. Eat the ice cream immediately or store it in the freezer.
b. Allow the yoghurt to cool to room temperature and then store in the refrigerator.
After the end of the programme, we recommend leaving the mixture in the switched-on
device for about 2 hours (the device cools the mixture automatically)
14. If desired, you can continue with the production of the yoghurt / ice cream
immediately following this. Start again at Point 1 to this end.

Follow-up cooling function

16.3.3
The follow-up cooling function starts automatically following the production of the ice
cream / yoghurt.
Ice Cream:
If the ice cream is not removed from the device 10 minutes after its production or the
device is not switched off, the follow-up cooling function will start, which is indicated on the
display as "COOL". In 10-minute stages, the device then cools your ice cream for one
hour.
Following its production, follow the steps for the removal of the ice cream / yoghurt. Please
note that the device only cools in this process and therefore the consistency inside and
outside of the container may vary. Mix the mixture following the removal of the mixer and
before filling it into an appropriate container.
YOGHURT:
When the yoghurt program has finished and the yoghurt is ready, the display will show
"00:00". The device automatically starts the follow-up cooling function with the display
showing "COOL".
Please note
39