Woods BRUSHBULL BB48XE Manuel D'utilisation page 9

Quick Hitch Attachment - BB48XE Only (Figure 3)
1.
Remove brace arms (6), floating link (3), cap screw (11), spacer (7), and
flange lock nut (9) from upper hole on A-frame bars (5) as shown on left
in Figure 3.
NOTE:
A-Frame bars are installed to mast plates with carriage bolts
through the square holes.
2.
Attach open end of floating link (3) to the bottom hole of A-frame bars (5).
Secure using cap screw (11), sleeve (10), and flange lock nut (9) as
shown on right in Figure 3.
3. Floating link
5. A-frame
6. Diagonal braces
7. 1/2 x 2-3/4 Spacer (12.7 x 69.9 mm)
8. 1/2 NC x 4" Cap screw
(12.7 x 101.6 mm)
MAN1254 (3/16/2018)
9. 1/2 NC Flange lock nut
10. 1/2 x 3/4 x 2-13/16 Sleeve
(12.7 x 14.05 x 71.44 mm)
11. 1/2 NC x 5 Cap screw
(12.7 x 127 mm)
Figure 3.
Standard Hitch and Quick Hitch Configurations - BB48XE Only
& BB72XE
Figure 4.
Standard Hitch and Quick Hitch Configurations - BB60XE, BB72XE & BB84XE
3.
Attach closed end of floating link (3) to diagonal braces (6). Secure using
cap screw (8), spacer (7), and flange lock nut (9) supplied in hardware
bag.
NOTE:
Quick hitch top hook will pick up on sleeve (10). Lower quick
hitch hook will attach to cutter hitch pins.
4.
Raise cutter to transport position and adjust tractor top link until cutter is
level in the raised position.
BB60XE
BB84XE
BB48XE
Operation 9