Woods BRUSHBULL BB48XE Manuel D'utilisation page 24

2. A-Frame bar
3. Upper mounting hardware
4. Diagonal brace
5A. Diagonal brace bar
mounting hole
5B. Tailwheel pivot hole
6. Tailwheel bracket
9. Tailwheel
10. Height adjustment
13. Driveline (Slip clutch)
14. Clutch shield
15. Rubber shield
14
13
4
2. A-Frame bar
4. Diagonal brace bar
6. Tailwheel bracket
Figure 31
. Shipping Unit Disassembly (BB48XE Shown)
DISASSEMBLE SHIPPING UNIT (Figure 31)
Remove all parts that are wired and strapped to cutter.
Remove cap screws (13) and flange lock nuts (14) that are securing A-frame
bars (2) to the cutting height adjustment holes (10).
Remove cap screws (13) and flange lock nuts (14) that are securing tailwheel
bracket (6) and diagonal brace bars (4) to cutter.
24 Assembly
9
Figure 30.
BB60XE, BB72XE & BB84XE Shipping Configuration
14
2
13
10
6
13
14
DP5A
10. Height adjustment
13. 5/8 NC x 2 Cap screw
14. 5/8 NC Flange lock nut
14
15
4
13
3
2
INSTALL TAILWHEEL
1.
Attach tailwheel bracket (6) to cutter at the tailwheel pivot holes (5B)
using cap screw (13) and flange lock nut (14) previously removed.
NOTE:
Make sure grease fitting on tube is on top when installing tail-
wheel.
2.
Select desired height adjustment holes (10), and secure tailwheel bracket
with cap screws (13) and flange lock nuts (14). Cutting height adjustment
will be necessary when cutter is fully assembled. See page 11.
3.
Raise rear of cutter and insert tailwheel assembly (9) into tailwheel
bracket (6). Secure with washer (37) and spiral pin (28).
10
6
5B
5A
MAN1254 (3/16/2018)