Transformation For Operating With Other; Replacing Gas Oven Burner Nozzle; Adjusting Oven Burner Minimum - Diamond G60/4BFEV6 Mode D'emploi

12
disassemble the panel (12), unscrew the connection hoses to the
burners (13), unscrew the ramp clips (14), pull the thermocouple off the
top of the gas cock and then replace the cock.
Thermocouple (15):
pull the thermocouple fitting off the back of the cock,
unscrew the nuts of the thermocouple support bracket (16),
replace the thermocouple.
Spark plug (17):
21
pull the spark plug connection cable off (18),
remove the retaining spring (20),
pull the spark plug off
Piezoelectric igniter (19) see previous photos:
remove the panel, pull the spark plug connection cable off (18), remove
the fixing nut (21) of the piezoelectric igniter and replace it.
6.2

TRANSFORMATION FOR OPERATING WITH OTHER

GASES – GAS OVENS
The equipment is inspected and set up to operate with natural gas (see
Feature table near the gas inlet on the appliance).
Proceed as follows to operate with other types of gas:
1. qualified personnel must perform this transformation;
LPG nozzles are supplied inside a nylon bag.
2.
6.2.1

REPLACING GAS OVEN BURNER NOZZLE

14
13
6
16
20-17
After having removed the burner sole, loosen the fixing screw of the
burner (22) and extract it from the support together with the heating
element and the ignition spark plug. Using a number 7 socket spanner,
unscrew the nozzle (23) and mount the new one making sure it is
screwed on all the way. Mount the burner, acting in inverse order. Then
put the burner sole back on.
6.2.2

ADJUSTING OVEN BURNER MINIMUM

19
18
22
23
24
(minimum
adjustment
screw)
16