Samsung RS58K Serie Mode D'emploi page 34

Installation
To connect the water filtering hose to the water line
a
A
a
B
A. Water Line from unit
B. Water Line from Kit
To repair the water line
CAUTION
The waterline must be repaired by a qualified professional. If you encounter a water leak,
contact a local Samsung service centre or the installer of the waterline.
STEP 6 Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1. Plug the power cord into the wall socket to turn the refrigerator on.
2. Open the door, and check if the interior light lights up.
3. Set the temperature to the coldest, and wait for about an hour. Then, the freezer will be
slightly chilled, and the motor will run smoothly.
4. Wait until the refrigerator reaches the set temperature. Now the refrigerator is ready
for use.
STEP 7 Final check
When installation is complete, confirm that:
• The refrigerator is plugged into an electrical outlet and grounded properly.
• The refrigerator is installed on a flat, level surface with a reasonable clearance from the
wall or the cabinet.
• The refrigerator is level and is sitting firmly on the floor.
• The door opens and closes freely, and the interior light turns on automatically when
you open the door.
34 English
Untitled-74 34
1. Loosen and remove the compression
Remove cap
2. Tighten up the compression nut (a) to
a
3. Open the main water valve and check
03
4. If there are no leaks, dispense about a
nut (a) from the water line of the
refrigerator, and insert it to the water
filtering hose.
connect the water filtering hose and the
water line.
for any leaks.
3 liters of water before actually using
the refrigerator to remove impurities
inside the water filtering system.
7/18/2017 5:08:12 PM