Programming - JAROLIFT TDRRT01W Mode D'emploi Original

Teaching the radio code
1. Connect the radio receiver according to the installation instructions (see page 6).
2. Press the stop button of the TDRRT01W for approx. 3 seconds to activate the learning mode.
3. The connected motor will vibrate briefly and the LED indicator light will go out to signal that the receiver is in learning
mode for approx. 5 seconds.
4. Within these 5 seconds, press the UP and DOWN buttons of your transmitter simultaneously and then briefly press the
STOP button.
When the code has been successfully learned, the motor vibrates again.
The motor can now be controlled via the UP/STOP/DOWN buttons on your transmitter.
6.
SW
copying an existing radio code
1. A transmitter must already be taught.
2. Press the UP and DOWN buttons simultaneously on the already taught-in transmitter.
3. Press the STOP button 8 times on the already taught-in transmitter.
The connected motor vibrates briefly to signal that the receiver is in learning mode.
4. Within 5 seconds, simultaneously press the UP and DOWN buttons of the new transmitter to be taught-in.
5. Then immediately press the STOP button of the new transmitter to be taught-in.
If the code was successfully taught, the motor vibrates again.
The motor can now be controlled using the UP/STOP/DOWN buttons on both transmitters.
UP/DOWN 8 x STOP
deleting the radio code
ATTENTION! All taught-in hand-held and wall transmitters are deleted!
It is not possible to delete individual transmitters.
1. Press the UP and DOWN buttons simultaneously on a taught-in transmitter.
2. Then press the STOP button 6 times.
3. Then press the UP button immediately.
If the radio codes have been successfully deleted, the motor vibrates.
UP/DOWN 6 x STOP
M
5 sec.
M
5 sec.
UP/DOWN
M
1 x OPEN
M
M
1 x STOP

PROGRAMMING

17