Assembly / Function Overview - JAROLIFT TDRRT01W Mode D'emploi Original

ASSEMBLY
mounting the radio receiver
Observe the connection diagram on page 6.
• The mains connection of the radio receiver and all work on electrical installations may only be carried out by an authorised
electrician in accordance with the connection diagrams in this manual. by an authorised electrician in accordance with the
connection diagrams in this manual.
• Carry out all installation and connection work in a de-energised state.
1. Push the power supply unit out of the inner support frame and the ou-
ter frame. To do this, hold the outer frame firmly at the side and press
against the power supply unit from behind.
2. First fix the support frame in a suitable flush-mounted box. flush-
mounted box.
3. Install the connections according to the wiring diagram in this manual.
instructions.
When connecting, make sure that the power supply unit is already
must already be on the outer frame before connecting it! must be!
4. After the connection has been made, press the receiver module (pow-
er supply unit), including the outer frame, into the previously installed
support frame.
function overview
Automatic mode Activate / Deactivate
Activate automatic mode: Press the buttons
STOP and K2 simultaneously for approx. 3 seconds.
The "Alarm clock" symbol appears in the display.
16
Activate automatic mode: Press the buttons STOP
and K2 simultaneously for approx. 3 seconds.
The "Alarm clock" symbol goes out.
ATTENTION!
When using the Automatic
mode should be the jog
mode (see page 8) should
be deactivated! be deac-
tivated!