During Use; Before First Use; Intended Use; Operation - Batavia BT-CRH001 Mode D'emploi

• Always use the auxiliary handle supplied
with the tool.
• Do not place pressure on the tool – to do
so could shorten its service life.
• Drill bits become hot during operation.
Allow to cool prior to handling.
• If you are interrupted when operating the
drill, complete the process and switch off
before diverting your attention elsewhere.
• Always disconnect the SDS drill from the
electric supply before changing a chisel or
drill bit.
• Examine the chuck regularly for signs of
wear or damage. Have damaged parts
repaired by a qualified service centre.
• Always wait until the drill has come to a
complete stop before placing it down.
• On completion of the work, disconnect the
tool from the power source and remove
the chisel/bit from the machine.
• Periodically check all nuts, bolts and other
fixings and tighten where necessary.
• Visibly check the tool after use, especially
the power cable, which can be damaged
by sharp masonry.
• Always fit the dust guard to the bit in use
to prevent damage from debris entering
the SDS chuck.
• If operating the tool causes discomfort in
any way, stop immediately and review your
method of use.

DURING USE

• Hold power tool by insulated gripping
surfaces (7), when performing an opera-
tion where the cutting accessory or fas-
tener may contact hidden wiring (cutting
accessory and fasteners contacting a
"live" wire may make exposed metal parts
of the power tool "live" and could give the
operator an electric shock)
• In case of electrical or mechanical mal-
function, immediately switch off the tool or
unplug charger from power source.

BEFORE FIRST USE

Remove the machine and the accessories from
the packaging. Check the machine for trans-
port damage and do not use the machine in
case of damages. Keep the packing materials
away from children, risk of suffocation!

INTENDED USE

The SDS Plus Hammer drill is designed for
drilling masonry. Also capable of drilling wood
and metal with the optional purchase of a
standard chuck with SDS Plus connector. The
equipment is to be used only for its prescribed
purpose.

OPERATION

Auxiliary Handle
• The auxiliary handle (13) should always be
used when drilling.
• The auxiliary handle (13) can be rotated
360° around the drill head, enabling safe
and comfortable operation for both left
and right-handed users.
To adjust the auxiliary handle:
1. Rotate the grip anti-clockwise. This will
loosen the handle assembly.
2. Move the side handle to the required
position.
3. Secure in position by rotating the grip
clockwise.
Depth Stop
1. Rotate the grip anti-clockwise. This will
loosen the handle assembly.
2. Move the depth stop (18) to the required
position.
3. Secure in position by rotating the grip
clockwise.
Operating the Chuck
• This rotary hammer has a chuck designed
for SDS Plus drill bits.
• The SDS Plus system allows bits to be
inserted with a simple push-fit action.
• Always grease the tail end of SDS bits.
Bits should be freshly greased and free
from dirt and dust before use.
Inserting a Drill Bit
1. Pull back the chuck collar (15) and hold.
2. Insert SDS Plus drill bit (17) fully into the
chuck (16). Use a twisting motion to line
up the grooves in the accessory.
English
7