Installation Instructions; Side View - Excel XLERATOR Manuel D'installation Et De L'utilisateur

R E A D A N D S A V E T H E S E I N S T R U C T I O N S
1. Disconnect the power source previously brought to the hand
dryer location (see pre installation wiring).
2. Remove the 2 cover mounting screws using the
Tamper-Proof Wrench supplied. Lift the cover to remove
from base plate.
3. If electrical wiring entry is to be made from the rear, remove
the appropriate pre-formed knockout on the base plate. If
entry is to be made from the bottom, knock out the
pre-formed area on the cover for your supply connection.
A rigid conduit must be used for the electrical wiring to the
unit.
4. Select the appropriate mounting height for dryer. (Table 1)
Select the recommended fastener (Table 2). There should be
no obstruction between the hand dryer and the floor. If
mounting over a countertop, distance from counter to dryer
must be 15" (381 mm) minimum.
CAUTION: Do not use the Base Plate as a guide when
drilling. Make sure no pipe work (gas, water, air) or any
electrical cables or wires are located directly behind the
area to be drilled.
5. Attach Base Plate at the four corners to a smooth wall.
For most secure installation, use 2 additional mounting holes
as shown in drawing. For non-HEPA units, remove Control
Assembly to access the right side mounting hole.
For HEPA units, remove filter only to access the right side
mounting hole.

SIDE VIEW

TABLE 1
SUGGESTED MOUNTING HEIGHT
1
from floor to bottom of dryer:
Men 45" (114 cm)
Women 43" (109 cm)
Teenagers 41" (104 cm)
Small Children 35" (89 cm)
Accessible 37" (94 cm)
E X C E L D R Y E R , I N C
3 5 7 C H E S T N U T S T R E E T, E A S T L O N G M E A D O W , M A 0 1 0 2 8

INSTALLATION INSTRUCTIONS

1 . 8 0 0 . 2 5 5 . 9 2 3 5 E X C E L D R Y E R . C O M
6. Identify the voltage of your dryer from the rating sticker of
the unit. Then connect to a dedicated branch circuit not
exceeding 20 Amp.
7. Secure electrical wiring to terminals as indicated by the
schematic affixed to blower housing. An identified ground
connection point is supplied on the Base Plate for your
equipment ground wire. Dryers should be installed per local
code requirements.
8. Carefully replace Cover using the 2 screws previously
removed in step 2. Restore power and test for proper
operation. In multiple installations, make sure the serial
number marked on the inside matches the cover number.
9. It is highly recommended that a bead of silicone sealant be
placed around the outside of the cover at the wall to protect
dryer from internal corrosion caused by wash water and
cleaning solutions.
10. Return Tamper-Proof Wrench to owner.
FRONT VIEW FACING WALL
TABLE 2
MOUNTING HARDWARE
2
Recommended Fastener (not supplied):
Masonry Wall ½" Expansion Sleeve with ¼" Lag Bolt
Hollow Wall ¼" Wing Type Toggle Bolt
Wooden Wall ¼" Lag Screw With Washer
A D M I N @ E X C E L D R Y E R . C O M
0 7 / 2 0 1 7 2