Installation; Before The Installation; Connection Cable - Electrolux EQT4520BOG Notice D'utilisation

Problem
and a number come on. There is an error in the hob. Disconnect the hob from
comes on.
comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also three
digit letter code for the glass ceramic (it is
in the corner of the glass surface) and an

8. INSTALLATION

8.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.

8.3 Connection cable

• The hob is supplied with a connection
cable.
WARNING!
Refer to Safety chapters.
Possible cause
The electrical connection is
incorrect. The supply volt-
age is out of range.
The cooling fan is blocked.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05BB-F Tmax 90°C.
Speak to your local Service Centre.
8.4 Electrical connection
ENGLISH
Remedy
the electrical supply for
some time. Disconnect the
fuse from the electrical sys-
tem of the house. Connect
it again. If comes on
again, speak to an Author-
ised Service Centre.
Speak to a qualified electri-
cian to check the installa-
tion.
Check if objects block the
cooling fan. If comes
on again, speak to an Au-
thorised Service Centre.
230V~
15