Commissioning And Operation - Klarstein PLUTO Mode D'emploi

EN
26

COMMISSIONING AND OPERATION

Before first use
• Before use, first remove all packing materials, including bottom padding, foam
pads and adhesive strips inside the freezer.
• Tear off the protective film on the freezer door and on the cabinet.
• Keep the unit away from heat and direct sunlight. Do not place the unit in damp or
wet places to avoid rust.
• Do not spray or wash the freezer or place it in damp locations where it will be
exposed to water splashes. This may affect the electrical insulation properties.
• The freezer must be placed in a well-ventilated area where the floor is flat and firm.
Use the adjustable feet to compensate for slight unevenness.
• The clearance to the ceiling should be at least 30 cm and the appliance should be
placed against a wall with a distance of more than 10 cm, so that the heat can be
dissipated.
• Before using the freezer for the first time, let it stand for at least half an hour before
connecting it to the power.
• Let the freezer run for 2-3 hours before putting fresh or frozen food in it. If the
outside temperature is high, let it run for at least 4 hours before filling.
• Leave enough space to open the drawers and doors comfortably.