Fox 32 FLOAT Mode D'emploi page 13

SERVICE
Properly cleaning your FOX product between rides, in addition to maintenance service scheduled at
regular intervals, will help to reduce repair costs and extend product life.
For further service procedures information, visit www.ridefox.com/OwnersManuals, or contact FOX for
complete maintenance service (1.800.369.7469 or mtbservice@ridefox.com).
Minimum Recommended Service Items
Inspect the entire exterior of your fork/shock.
The fork/shock should not be used if any of the
exterior parts appear to be damaged. Contact
your local dealer or FOX for repair.
Check that quick-release levers and axles are
properly adjusted and tightened.
Check your headset adjustment. If loose, adjust
it accordingly to your bicycle manufacturer's
recommendations.
Check that all brake cables or hoses are
properly fastened. Test the proper operation of
your front and rear brakes on level ground.
Clean exterior with mild soap and water only,
then wipe dry with a soft towel. Do not use a
high-pressure washer or spray water directly at
the seal/shock body junction.
Check sag and damper settings. Inspect the
controls for visual damage and function.
Full service (full internal/external inspection,
damper rebuild, air seal replacement for air
shocks, air spring rebuild, bath oil and wiper
replacement).
*For those who ride lift-accessed DH, Park, or Extreme Freeride or in extremely wet/muddy
or dry/dusty environmental conditions where trail debris is sprayed onto the fork while on
the trail, FOX encourages riders to perform maintenance earlier than recommended above as
needed. If you hear, see, or feel something unusual, stop riding immediately and contact a FOX
Authorized Service Center for proper servicing.
SEE ADDITIONAL INFORMATION AND VIDEOS:
ridefox.com
Before After
every every Regularly
ride ride
X
X
X
X
X
13
Every 125 hours or
yearly, whichever
comes first*
X
X