Assembly Instructions - Weston 83-0850-W Mode D'emploi

ASSEMBLY INSTRUCTIONS

1. Attach the gauge plate to the unit
by inserting the (2)screws through
the holes in the plate support,
affixing the washers and cap nuts
from the back of the unit (FIGURE
10).
2. Attach the blade support by
lining up the support with the
motor housing and turning the nut
clockwise (from front of the unit),
using a #10 wrench, until the washer
is tight against the housing.
3. Secure the blade support by
securing the bolt through the top
of the motor housing (FIGURE 11).
Tighten the bolt with a #10 wrench.
Place the recessed nuts in the
blade support (FIGURE 11). Screw
the Phillips head screws into the
holes through the back of the blade
support. Use your finger to secure
the nut while threading the screw.
4. Attach the blade, lining up the
screw holes on the blade with the
screw holes in the motor housing.
Secure 3 screws using a Phillips
screwdriver. (FIGURE 12)
5. Affix the plate to the center of
the blade (aligning the square peg
with the square hold) and secure
with the Blade Locking Screw w/
Knob through the back of the motor
housing. (FIGURE 13)
6. Mount the sliding food carriage
by lining up the hole on the carriage
with the bolt on the front of the
sliding arm. Secure the locking knob
to the bolt on the front of the unit.
7. Attach the plastic guard to the
inside of the sliding food carriage so
that the screws are inserted through
the plastic from the blade side of
the unit. Secure the pusher in place
by screwing the cap nuts onto each
screw.
10
CAUTION
SHARP Blade
Blade
Locking
Screw
FIGURE 10
FIGURE 11
FIGURE 12
FIGURE 13