Mounting Diagram; Floor Mounting - Chauvet Professional MAVERICK SILENS 2 PROFILE Manuel De Référence

EN
USB Software Update
The Maverick Silens 2 Profile allows for software update through USB using the built-in USB port. To update the software
using USB flash drive, do the following:
1. Power on the fixture and plug the flash drive into the USB port.
2. Once the flash drive has been detected, the message "Upgrade Firmware" will be displayed. Press ENTER. If a
different message appears on the display, search for the updated software in the Menu (Updated Firmware). A
list of the updated software files will be displayed.
3. Select the file that needs to be uploaded. The message "Are you sure?" will be displayed. Press ENTER.
4. If the selected file is correct, the upgrade will be completed. Restart the fixture. If the selected file is incorrect, the
upgrade will fail, and the display will go back to the main interface. Repeat steps 1-3 using the correct file.
The .chl format file needs to be placed in the MAVERICK folder in the USB flash drive.
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our Chauvet line of mounting clamps, go to
http://trusst.com/productcategory/truss-clamps/.

Mounting diagram

Safety cable
Overhead Mounting
Battery-powered Display
Press and hold until menu screen appears (approximately 15 seconds). Pressing the left center button also activates the
battery backup display.
Followspot Mode
The followspot mode disables the pan and tilt motors, allowing the output of the product to be aimed by hand. To enable
the followspot mode of the Maverick Silens 2 Profile, hold <UP> and <LEFT> while the product is powering on. When the
product is turned off and back on, the pan and tilt will return to normal function.
3
QUICK REFERENCE GUIDE
Safety Notes. Use at least two mounting points per product. Make sure the
Mounting clamps
Hanging brackets

Floor Mounting

Maverick Silens 2 Profile QRG Rev. 7