Vortice VORT HRI PHANTOM Livret D'instructions page 21

ENGLISH
Set required room temperature (fig.15).
15 15
FILT
1 2 3
esc
Prg
/ °C
By-Pass
Activate "bypass" function (fig.16)
16 16
FILT
1 2 3
esc
Prg
/ °C
By-Pass
Activate time/outdoor temperature display (fig.20)
17 17
FILT
1 2 3
esc
Prg
/ °C
By-Pass
User menu
18 18
FILT
1 2 3
esc
Prg
/ °C
By-Pass
P1 P2
4 5 6 7
set
P1 P2
4 5 7
6
set
P1 P2 HA
4 5 7
6
set
P1 P2 HA
4 5 6 7
set
Before proceeding with the steps indicated below, press the
ESC button to exit and return to the initial menu.
The preferred room temperature can be selected as follows:
- press and hold the SET button
P1/P2
- press the SET button briefly (the current value flashes)
- select the required value using the UP and DOWN buttons
- press the SET button briefly to retain the setting
- press the ESC button briefly to exit.
The purpose of the bypass function is to ventilate the apartment
without heat transfer. With the bypass valve open, air can be
introduced directly from outside, without passing through the
heat exchanger. The flow of air vented from inside continues to
pass through the heat exchanger.
P1/P2
Before proceeding with the steps indicated below, press the
ESC button to exit and return to the initial menu.
The "bypass" function can be forced by pressing and holding
the ESC button. The corresponding "money box" icon will light
up.
Before proceeding with the steps indicated below, press the
ESC button to exit and return to the initial menu.
The current values of the "time" and "outdoor temperature"
parameters can be viewed in alternation by pressing the ESC
button briefly.
Before proceeding with the steps indicated below, press ESC to
exit and return to the opening screen. As a rule, the parameters
relative to the various options are selected by pressing SET (this
causes the current value to blink), then scrolling through the
available values with the UP and DOWN buttons, and pressing
SET again to confirm the new value. The UP and DOWN buttons
are also used to scroll through the different options or
parameters. The main user menu can be viewed by pressing
and holding ESC and SET at one and the same time. The
options of the menu are:
21