Victron energy BlueSolar MPPT 150/85 Manuel page 13

4.5 Remote on-off
The charge controller will switch on if:
a) A wire link is present over the REMOTE terminals (default factory wire setting).
b) The left-hand REMOTE terminal (marked as B+) is connected to the positive
terminal of the battery (12/24/36/48V). Use wire with a cross-section of 0,75mm²
and insert a 0,1 A fuse close to the battery.
c) A voltage source of 3-60V (with respect to the negative battery terminal) is
connected to the REMOTE B+ terminal.
In case a, the charge controller will switch off if the wire link is removed/interrupted.
In case of b or c, the charge controller will switch on if the voltage is > 5 V.
If the voltage is < 3 V, the charge controller will switch off.
5. MORE INFORMATION ABOUT THE LCD SCREENS
5.1 Scrolling through the LCD screens
The following information will be displayed if the "-" button is pressed (in order of
appearance):
Displayed info
Battery charge current
(+system voltage)
Battery voltage (+system
voltage)
Battery power
Battery kWh-meter total
Battery kWh-meter today
Battery max power today
Battery kWh-meter yesterday
Battery max power yesterday
Battery temperature
Charger temperature
PV current
PV voltage
PV power
Table 4: scrolling through the LCD screens
Pressing the "-" button or the "+"button for 4 seconds activates the auto-scroll-mode.
Now all LCD-screens will pop-up one by one with short intervals.
The auto-scroll-mode can be stopped by pressing the "-" or the "+" button shortly.
Backlight: The LCD backlight will slowly fade one minute after pressing one off the buttons.
Visible icons
Battery
Battery
Battery
Battery
Battery
Battery
Battery
Battery
Battery + thermometer
Thermometer
Solar panels
Solar panels
Solar panels
Visible units
A (default)
V
W
kWh
kWh + Day
W + Day
Y + kWh + Day
Y + W + Day
0 0
C (or F)
0 0
C (or F)
A
V
W
13