Maintenance And Storage; Important Notice - Ezetil EZC 25 Mode D'emploi

Switch-off voltage
12 V operation
24 V operation
Switch-on voltage
12 V operation
24 V operation
It is absolutely necessary to disconnect the cooler from the battery when a high-rate charger is being used.
When used in a tip-up truck cab, switch off the cooler before tipping the cab forward.
Useful advice:
Foodstuffs and beverages stored in the cooler should always be in closed containers or wrapped so that air can circulate around these
refrigerated items. Do not place warm or hot foods or beverages into the cooler.

6. Maintenance and storage

A heavy build-up of frost and ice in the unit will reduce its cooling effect. Do not use sharp objects to remove the layer of frost and
ice; instead, switch off the unit and allow it to defrost. It is recommended that the unit be regularly defrosted.
If the unit is not in use over an extended period of time, open the lid enough to produce an air gap so that fresh air can circulate in
the cool-space.

Important notice:

Maintenance or repair work, particularly on the cooling aggregate, cooling circuit or electronics, may only be performed by qualified
technicians.
Troubleshooting notice:
Before you call customer service with a problem, we recommend that you check the following aspects:
• Is the unit in a suitable location where it has adequate ventilation?
• Does the outlet where the unit is connected have power?
• Is the connecting cable damaged?
• Is the plug fully inserted into the outlet?
• Is the unit switched on?
The unit has its own fault diagnostic system that helps to find the source of problems. Watch the LED next to the on/off
button:
1 blink: the input voltage is too low
2 blinks: ventilator current is too high
3 blinks: compressor start-up fault, locked rotor
4 blinks: compressor speed fault, the cooling system is overloaded
5 blinks: compressor over-temperature shutdown
If the LED indicates faults 3, 4 or 5, empty the cooler put it in a cool location and then try to start it again.
If "Er" appears in the temperature display, the temperature sensor may be faulty. This unit has an emergency-operation system for this
case. This will maintain a minimum level of cooling. The temperature cannot be precisely regulated under these conditions.
If these checks do not lead to flawless operation of the unit then please contact customer service.
7. Releasing the lid's hinge (only models 25, 35, 45)
If the cooler is to be used in a confined space where raising its lid is difficult, you can release the lid hinge to make the lid
removable.
Loosen the lid latch with a screwdriver as shown in the illustration (later picture). Once this has
been done, the lid need only be open to an angle of about 20° to remove or replace it.
18265_EZetil_KompressorBedienAra8 18265_EZetil_KompressorBedienAra8
GB
USER INSTRUCTIONS Cooler and Freezer
High
11.3 V
24.6 V
12.5 V
26.0 V
8 8
Med
10.8 V
23.6 V
12.0 V
25.0 V
– 8 –
Low
10.0 V
22.0 V
11.3 V
23.4 V
10.03.2008 10.03.2008 9:30:19 Uhr 9:30:19 Uhr