Beurer medical BC 28 Mode D'emploi page 24

Adopting the correct posture
• Before every measurement, relax for about five min-
utes. Otherwise deviations can occur.
• You can take the measurement while sitting or lying
down. To take your blood pres-
sure, make sure you are sitting
comfortably with your arms and
back leaning on something. Do
not cross your legs. Place your
feet flat on the ground. Make sure
to rest your arm and move it. Always make sure that
the cuff is at heart level. Otherwise significant devia-
tions can occur. Relax your arm and the palm of your
hand.
• To avoid falsifying the measurement, it is important to
remain still during the measurement and not to speak.
Performing the blood pressure measurement
As described above, attach the cuff and adopt the postu-
re in which you want to perform the measurement.
• Press the START/STOP button
to start the blood pressure monitor.
All displays will illuminate briefly.
• The last measured value is dis-
played and the blood pressure mo-
nitor automatically begins the mea-
surement after 3 seconds.
As soon as a pulse is found, the pulse symbol
displayed.
• The systolic pressure, diastolic
• • • • • • • • • • • • •
•
• Now select the desired user memory by pressing the
• Press the START/STOP button to switch
If you forget to turn off the device, it will switch off auto-
matically after approx. 1 minute.
24
You can cancel the measurement at any time by
pressing the START/STOP button
pressure and pulse rate measure-
ments are displayed.
_ appears if the measurement has not been
performed properly. Observe the chapter
on error messages/troubleshooting in
these instructions for use and repeat the
measurement.
memory button M. If you do not select a user memory,
the measurement is stored in the most recently used
user memory. The relevant
the display.
blood pressure monitor. The measurement is then
stored in the selected user memory.
will be
or symbol appears on
off the