Selecting The Last Source; Adjusting The Volume; Muting The Sound; Changing Channels - HP MediaSmart SL4778N Manuel De L'utilisateur

The list of input sources identifies a connector set on
the rear of the TV:
Antenna or Cable is the ANT/Cable In
■
connector. The label shows the scan source
selection (Antenna or Cable) of the last channel
scan performed by either the Setup Wizard or the
Channel menu.
AV1 is the Standard Definition Input AV Input 1
■
connector set of S-Vid or Video.
AV2 is the Standard Definition Input AV Input 2
■
connector set of S-Vid or Video.
Component 1 is the Component High Definition
■
Input 1 connector set.
Component 2 is the Component High Definition
■
Input 2 connector set.
HDMI 1 is the Digital High Definition Input
■
connector HDMI 1.
HDMI 2 is the Digital High Definition Input
■
connector HDMI 2.
HDMI 3 is the Digital High Definition Input
■
connector HDMI 3.
PC is the PC Input (VGA) connector set.
■
MediaSmart shows the digital media menus as
■
if you pressed the Media button.
You can change all the labels except Antenna (or
Cable) and MediaSmart. Use the onscreen display
Setup menu to change the label in the source list; see
"Changing the Input Labels" on page 64.

Selecting the last source

Press the Last Source button on the remote control to
change the input source to the last viewed source.

Adjusting the Volume

To increase or decrease the sound, press:
The remote control Volume buttons.
■
Or
The TV Volume buttons.
The indicator bar on the TV shows the increase or
decrease in volume.
36
HP MediaSmart HDTV User Guide

Muting the sound

1
Press the Mute button on the remote control to
temporarily turn off the sound.
2
Press the Mute button again to restore the sound
back to the previous level.

Changing Channels

To change to the next higher or lower channel, press:
The remote control Ch+ or Ch– buttons.
■
Or
The TV Channel buttons.
To change to another channel, enter a one-digit,
two-digit, or three-digit number, or press the channel
up or down buttons.
To select a specific channel number (for example,
channel 25), complete the following procedure within
four seconds:
1
Press the 2 button on the remote control.
2
Press the 5 button.
3
Press Enter.
To select a specific digital channel number (for
example, 14-2) complete the following procedure
within four seconds:
1
Press the 1 button on the remote control.
2
Press the 4 button.
3
Press the – (dash) button.
4
Press the 2 button.
5
Press Enter.

Selecting the last channel

Press the Last button on the remote control to view the
previous channel that you viewed.
Ch +
Ch –