Die Installation; Preparing Cable - Greenlee EK425VX Mode D'emploi

Die Installation

Installing K22, KA22, and KC22-type Dies
in CJ22 Jaw
1. Pull the die release button.
2. Slide the die into the crimping head until it "snaps"
into place.
3. Properly position the second die. Repeat step 2.
Installing W-type Dies in CJD3 Type Jaws
1. Pull the die release button.
2. Slide the die adapter (Greenlee part number
50042920) into crimping head until it "snaps" into
place.
Note: The die adapters have the "D
additional dies are needed if the connector to be
crimped requires a "D
3. Repeat for the other adapter.
4. Push the W-type die detent and slide the W-type die
into place
5. Repeat step 4 to properly position the second die.
The following W-type dies may be used with the
Greenlee EK425VX Tool:
• Greenlee KD6 series
• Burndy W and X series
• ILSCO ND seriess
• Huskie HT58 series
• Panduit CD-2001 series
• Other industry W-type dies
Greenlee Tools, Inc.
Gator Insulated Battery-Powered In-Line Crimpers
®
" die profile. No
3
" die.
3

Preparing Cable

Follow the lug manufacturer's instructions for
appropriate cable strip length.
Crimping Direction
(evenly spaced)
First Compression
SIDE A
13
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
First Compression
Crimping Direction
SIDE B
(evenly spaced)
First Compression
SIDE B
Crimping Direction
SIDE A
(evenly spaced)