Approval Listing And Codes; Appliance Certification; Installation Codes; D’Installation - Heat-N-Glo AT-GRAND Mode D'emploi

Table des Matières

Publicité

1
Approvals and Codes

Approval Listing and Codes

Appliance Certification

The Heat-N-Glo models discussed in this Installers Guide
have been tested to certification standards and listed by the
applicable laboratories.
CERTIFICATION STANDARD
MODEL
AT-Grand
LABORATORY
Underwriters Laboratories
TYPE
Vented Gas Fireplace Heater
STANDARD
ANSI Z21.88•CSA2.33
f i r e - p a r t s . c o m

Installation Codes

The appliance installation must conform to local codes. Before
installing the appliance, consult the local building code
agency to ensure that you are in compliance with all
applicable codes, including permits and inspections.
In the absence of local codes, the appliance installation must
conform to the National Fuel Gas Code ANSI Z223.1 (in the
United States) or the CAN/CGA-B149 Installation Codes (in
Canada). The appliance must be electrically grounded in
accordance with local codes or, in the absence of local codes
with the National Electric Code ANSI/NFPA No. 70 (in the
United States), or to the CSA C22.1 Canadian Electric Code
(in Canada).
These models may be installed in a bedroom or bed-sitting
room in the U.S.A. and Canada.
Homologations et codes d’installation
Homologations et codes
L’appareil Certification
Les modèles Heat-N-Glo présentés dans ce Guide
d’installation ont été soumis à des tests d’homologation
standard et ont été approuvés par les laboratoires concernés.
CERTIFICATION STANDARD
MODÈLE
LABORATOIRE
TYPE
STANDARD

Codes d’installation

L’installation doit être conforme aux codes locaux. Avant
d’installer cet l’appareil, consulter l’autorité locale en matière
de codes de construction pour assurer la conformité de
l’installation avec les codes et règlements locaux en vigueur.
En l’absence de codes locaux, se conformer au National
Fuel Gas Code ANSI Z223.1 (aux États-Unis) ou aux Codes
d’installation CAN/CGA-B149 (au Canada). L’appareil doit être
mis à la masse conformément aux codes locaux ou, en
l’absence de ces derniers, conformément au National Electric
Code ANSI/NFPA No. 70 (aux États-Unis) ou au CSA C22.1
Code Électrique Canadian (au Canada).
Ces modèles peuvent être installés dans une chambre à
coucher ou dans un salon aux États-Unis ou au Canada.
1
AT-Grand
Underwriters Laboratories
Cheminée à gaz ventilée
ANSI Z21.88•CSA2.33

Publicité

Table des Matières
loading

Table des Matières