Leica Geosystems DX10 Mode D'emploi page 13

Detaching the
DX10-R from a pole
step-by-step
Description of the System
Description
6.
DX10_09
7.
DX10_11
8.
DX10_10
Description
1. Unplug connector from DX10.
2. Screw out the safety screw of the bracket on the DX10.
3. Push the DX10 towards top of the PowerHolder to release the
clip from the pivot.
Always disconnect the cable between the DX10 and the
PowerHolder when the DX10 is not in use (over night, etc.).
DX10
Attach the clip at top end of
DX10 against the pivot on
PowerHolder. Lower DX10 into
the holder.
After DX10 is placed into the
holder ensure that the safety
screw under the PowerHolder is
screwed into the bracket on the
DX10.
Plug in connector to DX10.
Secure connector with safety
screws.
11