Product Specific Precautions - Franklin Electric SubDrive 15 Manuel Du Propriétaire

SAFETY INSTRUCTIONS

Product Specific Precautions

Product Specific Precautions
High voltages capable of causing severe
injury or death by electrical shock are
present in this unit.
• To minimize risk of electrical shock, disconnect power
before working on or around the system.
• Serious or fatal electrical shock may result from fail-
ure to connect the ground terminal to the motor,
drive, metal plumbing, or other metal near the motor
or cable, using wire no smaller than motor cable
wires.
• Do not use motor in swimming areas.
• Capacitors inside the drive can still hold lethal voltage
even after power has been disconnected—ALLOW 5
MINUTES FOR DANGEROUS INTERNAL VOLTAGE TO
DISCHARGE BEFORE REMOVING COVER.
Risk of damage to drive or other equipment.
• Install and wire product according to the instructions
in this manual.
• Take protective measures against ESD (Electrostatic
Discharge) before touching control boards during
inspection, installation or repair.
• Use this product only with Franklin Electric 4-inch
submersible motors as specified in this manual (Refer
to "Applications" on page
other Franklin Electric motor or with motors from
other manufacturers may result in damage to both
motor and electronics.
• In applications where water delivery is critical, a
replacement pressure sensor and/or back-up system
should be readily available if the drive fails to operate
as intended.
6
8). Use of this unit with any
Declarations
Wi-Fi Module
The Wi-Fi module has been tested and found to comply
with part 15 of FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference.
This equipment generates, uses, and can radiate radio fre-
quency energy for limited periods (approx. 15 min.) and, if
the drive is not installed and used in accordance with the
instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this
equipment does cause harmful interference to radio or tele-
vision reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following mea-
sures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV techni-
cian for help.