Optex Smart Line Serie Instructions D'installation page 10

When connecting to BCU-5 (OPTION)
BCU-5 allows to share power source and low battery signals between the main unit and the wireless transmitter.
For more information on connecting, see BCU-5 manual.
Main unit
Receiver
Red
Black
Yellow
Orange
Brown
Green
Blue
Purple
Gray
Transmitter
Main unit
Red
Black
Green
Blue
Warning
Do not insert batteres into the wireless transmitter,
when using BCU-5 option.
Doing so may result in fire or explosion.
Attach the BCU-5 to the battery plate
1
using double-sided adhesive tape.
• Be careful not to cover the power/low
battery indicator LED.
• Select a location that does not interfere
with the connector installation.
Battery Plate
Power/
Low battery
indicator LED
When connecting to PCU-5 (OPTION)
PCU-5 is used to enable wired operation.
For more information about
this option, see PCU-5
manual.
Back box
Battery
Plate
COM
N.C. Alarm
N.O.
Low battery
Tamper
Transmitter
Note>>
• If a wireless transmitter has an N.O. output, the low
battery output nor the tamper output can not be used.
Back box
Battery
Plate
Low battery
Transmitter
Note>>
• This section shows for reference as an example of
duplicate communication.
• It can usually be omitted because the low battery signal
of the transmitter is to be sent to the receiver through
the infrared beam.
Connect the Power line
2
(Red/Black) to the Battery
Plate.
BCU-5
Note>>
• Route the cables through
the center hole.
• When using PCU-5 (option)
with either the transmitter or
receiver, ensure that the low
battery signal is monitored
at the other which is battery
operated. Refer to PCU-5
manual.
EN-10
BCU-5
EX EX – +
Through the
center hole.
–
Wireless
+
BCU-5
Through the
EX EX – +
center hole.
Wireless
–
+
Wire the Red/Black line through
3
the groove of the Battery Plate,
so that the Battery Cover does
not pinch the line.
Battery Plate
BCU-5
–
+
–
+
Battery Plate