Connect To An End Node - D-Link DGS-1016D Manuel

Connect to an End Node

End nodes include PCs outfitted with a 10, 100 or 1000 Mbps
RJ-45 Ethernet/Fast Ethernet Network Interface Card (NIC) and
Ethernet ready routers. Use standard Ethernet cable to connect the
Switch to end nodes. Switch ports will automatically adjust to the
hardware characteristics (MDI/MDIX, speed, duplex) of the device
to which it is connected.
Switch connected to an end node
Observe the guidelines for cable quality stated at the beginning of
this section. The Link/Act/Speed LEDs for each port lights green
when the link is valid.
18