Philips sonicare FlexCare+ 900+ Serie Mode D'emploi page 14

ENGLISH
14
1 Place the handle with a brush head attached on the plugged-in
charger.
2 Press and hold the mode button for 2 seconds.
You hear 1 beep to indicate the Quadpacer has been deactivated
,
or you hear 2 beeps to indicate the Quadpacer has been activated.
Cord wrap on deluxe charger (specific types only)
If your type includes the deluxe charger cover and base, the travel charger is
pre-installed inside the cover. If you want to shorten the mains cord, you
can store excess cord in the cord wrap feature built into the charger base.
1 To separate the charger cover from the charger base, press the two
grey snap bars on the charger base and pull the white charger
cover upwards. (Fig. 9)
2 Wrap excess power cord around the grey charger base as shown
in the picture. Be sure to wrap the cord on the inside of the two
snap levers. (Fig. 10)
3 When you have stored the excess cord, guide the mains cord
through the small groove in the rear of the grey charger base.
(Fig. 11)
4 To reattach the charger cover, press it down over the charger base
until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel charger
and use it without the charger cover and charger base.
Cord wrap on sanitiser with integrated charger
(specific types only)
- If your type includes the sanitiser, you can store excess cord in the
cord wrap feature built into the bottom of the sanitiser. (Fig. 12)