Important Safety Instructions - Guest CHARGEPRO 1.5 Manuel Du Propriétaire Et Guide D'installation

INTRODUCTION
1
Introduction
Our newest generation ChargePro ™ 1.5 Amp Dual Use Maintainer and Charger is an innovative
product designed for maximum utility. Concealed mounting holes allow the ChargePro
to be installed on-board or to be used as a portable, with a rear die cut foam resting pad.
Ring terminal and DC clamp quick connect cable assemblies included.
Our marine grade design is weatherproof, water resistant to IP 65 and can be used in all fresh
and salt water outdoor and indoor applications as needed.
Designed to keep 12 volt batteries fully charged during short or long term storage periods,
ChargePro 1.5's Energy Saver mode will monitor and auto maintain a battery when needed
to maintain a full state of charge. ChargePro
lowers operating costs and maximizes reserve power performance.
Ideal for personal watercraft, recreational ski and wake boats, ATV's, autos,
tractors and more.
Guest's ChargePro ™ 1.5 Features Include:
Fully automatic energy saving design
•
Dual-use design, easily configures for on-board or portable use
•
Concealed mounting holes & die cut foam resting pad for portable use
•
Expanded LED display for Power, Charging and Auto Maintain status
•
Maintain 12 Volt Flooded, Gel & AGM lead acid batteries
•
Quick connect DC clamp and ring terminal cable assemblies
•
Weatherproof and water resistant to IP65
•
Built-in safety with reverse polarity, short circuit, temperature and ignition protection
•
Pre-wired for easy installation
•
3 year warranty
•
1.5 significantly reduces AC power consumption,
™

Important Safety Instructions

SAVE THESE INSTRUCTIONS
1.5
™
This manual contains important safety and operating instructions for the ChargePro
Amp Dual Use Battery Maintainer and Charger.
CAUTION
- To reduce the risk of injury, connect to only 12V Flooded, Gel and AGM
lead acid batteries. Other types of batteries may burst, causing personal injury.
Before connecting your batteries or applying AC power, read all instructions and cautionary
markings on the ChargePro
WARNING
To reduce the risk of injury to user or property; the user must read and understand the instruction
manual and all warnings on the ChargePro
WARNING
1. WARNING - RISK OF EXPLOSIVE GASES.
a. WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES
GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS
REASON, IT IS OF UTMOST IMPORTANCE THAT YOU FOLLOW THE INSTRUCTIONS
EACH TIME YOU USE THE CHARGEPRO
b. To reduce risk of battery explosion, follow these instructions and those marked on the battery.
c. Connect and disconnect battery leads only when supply cord is disconnected.
d. For a battery installed in a vehicle, first connect the POSITIVE (RED) Clip of the
ChargePro ™ 1.5 to the POSITIVE (POS,P,+) ungrounded post of the battery. Connect
NEGATIVE (BLACK) clip to vehicle chassis or engine block away from battery. Do not
connect clip to carburetor, fuel lines, or sheet-metal body parts. Connect to a heavy
gauge metal part of the frame or engine block.
e. Do not smoke, strike a match or cause a spark in vicinity of battery.
f. Use in well-ventilated area.
g. Refer to Instruction Manual for further details.
2. Use the ChargePro
intended to supply power to an extra-low-voltage electrical system or to charge dry-cell batteries.
Charging dry-cell batteries may burst and cause injury to persons and property.
3. Use of an attachment not recommended or sold by Guest
electric shock, or injury to persons.
4. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting the ChargePro
SAFETY INSTRUCTIONS
™ 1.5, cables, and batteries.
™ 1.5 and batteries before use.
™ 1.5.
™ 1.5 for maintaining and charging a 12V LEAD-ACID battery only. It is not
® may result in a risk of fire,
™ 1.5 Maintainer and Charger.
2
™ 1.5