Maintenance / Cleaning, Storage And Transportation - Keller HTP1 Notice D'utilisation

7 Maintenance / cleaning, storage and transportation

Maintenance
No maintenance is required for the hand pump and it cannot be repaired by the opera-
tor either. In the case of a defect the appliance must be sent back to the manufacturer
for repair.
â
Check the seals and O-rings for fractures and wear before use.
â
Replace defective or worn seals and O-rings.
Cleaning
Clean the hand pump with a dry or slightly damp lint-free cloth.
Do not use sharp objects or aggressive cleaning agents to clean the pump. Avoid
contact with aggressive media.
Storage and transportation
For storage and transportation we recommend our transportation case, which is avai-
lable as an optional accessory.
The tight-fitting rigid foam inlay offers optimum protection for the hand pump with pres-
sure hose and accessories.
Reference gauge
The common reference models fit into the gaps in the transportation case and do not
need to be removed.
Before storage, we recommend that you consider the
following points:
● Clean the hand pump and the accessories.
● Turn the fine adjustment valve in a clock w ise
direction until the thread is no longer visible
(➝ illustration).
● Open the pressure relief valve.
IMPORTANT! Do not store under pressure!
Only store the hand pump with the pressure relief valve open. This ensures that no
pressure can be built up by unintentional pumping movements.
36