Networking The Pdu - Tripp-Lite PDU3VSR6H50A Manuel Du Propriétaire

Installation
2-6
To access the terminal block to make
input wire connections, remove the
access plate located on the back side of
the PDU.

Networking the PDU

Your PDU can receive IP address assignments via DHCP server (dynamic) or static (manual)
addressing methods. See the SNMPWEBCARD installation guide on the included CD or visit
www.tripplite.com/manuals. If you are uncertain which method to use, contact your network
administrator for assistance before continuing the configuration process.
Note: The MAC address of the PDU (12-digit string in this format: 000667xxxxxx) is printed on a label attached
to the PDU enclosure. For static IP address assignments, use the RJ-45 to DB9 configuration cable (part
number 73-1243) included with the PDU.
13-09-017-9332B8.indb 7
Remove Access Plate Screws
Ground Terminal
2-6
7
X
Y
Z
N
9/5/2013 4:26:50 PM