General Warnings - Aspira CTF Serie Instructions De Montage

1.

GENERAL WARNINGS

ATTENTION! Read carefully the instructions in this booklet as they give important information on the
correct installation, use and maintenance of the appliance. Keep this booklet in a safe place so that it will
be available for future reference.
• After unpacking check the integrity of the set. In case of doubt do not use the set and ask for qualified person's
intervention.
All the packaging (plastic bags, polystyrene foam, nails, etc) must be kept out of the reach of children.
• Before connecting the appliance to the mains supply ensure that the rating label specifications correspond to
your electrical supply. (The rating label is to be found on the top part of the motor holder).
• This appliance must only be used for the purpose for which it was designed i.e. ventilation of rooms.
All other uses must be considered to be potentially dangerous. The Manufacturer cannot be held responsible
for any damage caused by improper, incorrect or unreasonable use.
• The safe use of any electrical appliance involves the observing of certain basic rules, in particular:
• Do not touch the appliance with wet or moist hands or feet.
• Do not use the appliance with bare feet.
• Do not pull the plug from the power socket by the mains lead of the appliance itself.
• Do not leave the appliance where it is exposed to adverse elements such as rain, salt etc.
• Do not let young children, aged or infirm people use the device without supervision.
• Before beginning any cleaning or maintenance operations disconnect the appliance from the electrical supply
by taking out the plug or switching off the appliance insolation switch.
• In case of a fault and/or malfunction of the appliance, switch it off but do not attempt to rectify.
Seek advice from a suitably qualified person.
If repair is necessary contact the Manufacturer and ask for only original spare parts.
If the above action is not carried out, the safety of the appliance could be jeopardized.
• Should it be decided not to use this appliance any longer, it should be removed from the electrical supply and
rendered inoperative, then disposed of in the normal manner. It is also recommended to make harmless those
parts of the appliance which could be harmful, especially to children who might play with the disused appliance.
• The installation must conform to the requirements of the latest issue of the I.E.E. wiring regulations.
• This appliance has been constructed to comply with the requirements of the following European Directives CEE
73/23 + CEE 93/68, CEE 89/336 + CEE 93/68.
• The set is workmanlike manufactured. A correct use and a regular maintenance guarantee life and reliability
of all electrical and mechanical parts.
The set is workmanlike manufactured. A correct use and a regular maintenance guarantee life and reliability
of all electrical and mechanical parts.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or lack
of experience and knowledge unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children should bensure that they do not play with the
appliance.
SPECIAL WARNINGS
• Installation must be carried out as detailed in these instructions. The user is warned that incorrect installation
could cause harm to persons or animals or damage to property. The Manufacturer cannot be held responsible
in such cases.
• The apparatus is double insulated (Class II) and does not require earthing.
• Check that the current carrying capacity of the mains wiring and socket are adequate for the maximum rating
of the device shown on the rating label. In case of doubt consult a suitably qualified person.
• When installing, it is necessary to use a double pole switch with a contact separation of 3 mm or more.
• Do not leave the appliance plugged if unnecessary. Switch off the main switch of the appliance when the
appliance is not in use.
• Do not obstruct the air inlet or outlet grilles.
• In conformity with prevention and safety laws in force, when installation of exhaust fan is completed, make sure
that it is not at all possible to reach the motion parts from the inlet side. On the contrary it is necessary to mount
the special protection shutter (cod. AP0885, cod AP0893).
• If there is already a combustion fuel appliance in the room, it is essential to ensure that the air supply to the
room is adequate for the correct functionning of both the combustion appliance and the fan.
Do not install the fan in the same duct where gas appliance fume is conveyed.
The appliance must discharge into a single exhaust pipe or directly outside the building.
4
E N G L I S H
CTF Series