Removal And Re-Installation - Dacor DOP36M96GL Serie Consignes D'installation

If the range does not operate properly, follow these troubleshooting steps:
1. Verify that power and gas are supplied to the range.
2. Check the electrical connections and gas supply to ensure that the installation has
been completed correctly.
3. Repeat the above bake test or burner ignition test.
4. If the appliance still does not work, contact Dacor Customer Assurance: 833-353-5483.
Do not attempt to repair the appliance yourself. Have the model and serial numbers
available when you call. See page 6 for location.
Dacor is not responsible for the cost of correcting problems caused by a faulty installation.

Removal and Re-installation

Removing the Range for Service
1. Turn the gas supply valve to the off position.
2. Turn off power to the range at the circuit breaker panel or fuse box.
3. Pull the range out from the wall
Reinstalling the Range After Service
1. Push the range into operating position, making sure the anti-tip bracket is engaged
(see page 40).
2. Turn on power to the range at the circuit breaker panel or fuse box.
3. Turn the gas supply valve to the on position.
Install_NX9900R_PRORANGE_DOP36M96_DA_DG68-01106C-02_EN+MES+CFR.indb 49
English 49
2019-08-13 6:30:56