Dacor DOP36M96GL Serie Consignes D'installation page 39

Before sliding the range into the cabinet:
1. Make sure the gas supply valve is in the off position and that power to the range is
off.
2. Connect a flexible gas supply line to the gas shut-off valve previously installed on the
stub out. The gas line needs to be long enough to allow the range to be pulled out for
service without being disconnected.
3. Slide the gas line up through the access holes in the chassis and up to the regulator.
Move the wires around inside the access holes to prevent them from catching on the
gas line as you push it up.
4. Connect the gas line to the regulator.
5. Turn all cooktop control valves to the "OFF" position. Turn on the gas supply.
6. Check all lines and connections for leaks using a soap and water solution.
7. After verifying that there are no gas leaks, turn off the gas supply valve connected to
the range to the "OFF" position.
Install_NX9900R_PRORANGE_DOP36M96_DA_DG68-01106C-02_EN+MES+CFR.indb 39
Back of range
Regulator connection
Gas line
English 39
2019-08-13 6:30:53