Local Device Network Settings - Aercus WeatherSleuth Mode D'emploi

Type the IP address you located from the IP Scan Tool into your web browser (example, Figure 21):
You are now communicating directly to the WeatherSleuth® and can proceed to Section 3.6.5.
If you cannot access the device, press the reset pinhole on the back of the module (reference Figure 15)
and wait for the lights to stabilise, and repeat by selecting the Search button again.

3.6.5 Local Device Network Settings

From your web browser, access the WeatherSleuth® from the IP address obtained in the previous
section.
Select the Local Network tab to programme the local network settings. Reference Figure 22:
1. IP Address. The default setting is receive automatically (DCHP), which is recommended. The
network will assign an IP address. To statically assign an IP address, select Static from the pull
down menu. This will prevent the IP address from changing each time you power up the
WeatherSleuth® receiver.
2. Static IP Address. If Static is selected as the IP address, enter the IP address you wish to
access the WeatherSleuth® device.
3. Static Subnet Mask. Default is 255.255.255.0. This should not be changed unless you are
familiar with networking and subnet masking.
4. Static Default Gateway. This is typically the IP address of your router.
5. Static DNS Server. This is your DNS Server setting based on your router connection.
6. Server Listening Port. Default is 5000. Enter an integer between 1024 – 65535.
If you made any Static IP Address changes (not recommended), to confirm these changes, select Apply
and Reboot.
Aercus Instruments™ - WeatherSleuth®
Figure 20
Figure 21
22 | P a g e